Skip to content
Care help

Installing the connector

Updated

These pages describe Care as it is today, and they change when it does.

On this page 4 sections
  1. Steps
  2. How it works
  3. If it does not connect
  4. Stopping it

The connector is a free WordPress plugin called AccessDossier Care. It has been sent to wordpress.org for review. Until it is listed there, download the plugin zip here, or email hello@accessdossier.com and we send it.

Care does not support WordPress installed in a subdirectory (for example example.com/blog) yet. The site must run WordPress at the root of its address.

Steps

  1. In WordPress, go to Plugins > Add New Plugin > Upload Plugin, choose the zip, then install and activate it.
  2. In Care, open the site and copy its connection key.
  3. In WordPress, go to Settings > AccessDossier Care, paste the key and click Connect.

Use HTTPS on the site. Care only talks to sites over HTTPS, so the answers travel encrypted.

How it works

The plugin never sends anything on its own. Care asks the site for its status, and the plugin answers only when the request is signed with that site's key and is less than five minutes old.

If it does not connect

  • Key not accepted: the key in WordPress is not this site's key. Copy it again from Care and paste it.
  • Connector not found: the plugin is not active, or a security plugin or firewall blocks the WordPress REST API at /wp-json/.
  • Site did not answer in time: the site took longer than 15 seconds to answer. Check that it loads, then try again.

Stopping it

Click Disconnect on the plugin's settings page. Deactivating the plugin also stops it, but keeps the key, so it starts again if you reactivate. Deleting the plugin deletes the key.